|
1. Check an epiploon for existence of signs of development of leaks. In case of need make replacement.
2. Carefully wipe outside a transmission case.
3. Completely merge transmission oil, then screw back and tighten with the demanded effort (44 Nanometers) a drain stopper with the demanded effort, - do not forget to establish into place a sealing washer.
4. Remove back section of system of production of the fulfilled gases with the muffler (see the Head of the Power supply system and release).
5. Uncover the thermofilter (see the Section Removal and installation of transmission assembly).
6. Remove the driveshaft (see the Head Stsepleniye).
|
|
7. By means of the special ST 398527700 adaptation remove an epiploon. |
|
|
8. Installation of a new epiploon is made by means of a special mandrel of ST 498057300salnik.
|
|
As a mandrel the replaceable face head of the corresponding size, or a piece of a pipe of suitable diameter will approach. Remember that the mandrel has to rest only against the rigid face region of an epiploon! |
|
9. Further installation is made as it should be, the return to an order of dismantle of components.
10. Fill in fresh oil in transmission and adjust its level (see the Head Routine maintenance). |
