Subaru of Legasi, Autbek
+ Cars Subaru Legacy, Outback
+ Operation manual
+ Routine maintenance
+ Engine
+ Cooling systems, heating
+ Power supply system and release
+ Electric equipment of the engine
+ Manual box and differential
+ Automatic transmission
+ Coupling
+ Brake system
+ Suspension bracket and steering
+ Body
- Onboard electric equipment
Specifications
Search of causes of failures of electric equipment
Safety locks - the general information
Chain breakers - the general information
The relay - the general information and check of serviceability of functioning
Details of laying of an onboard electrical wiring
System of additional safety (SRS) - the device and the principle of functioning
Diagnostics of malfunctions of SRS
Removal and installation of the SRS components
Control system of speed (tempostat) - the device and the principle of functioning
Check of serviceability of functioning of components and problem diagnostics of a tempostat
Removal, check of a state and installation of components of a control system of speed
Combination of devices - the general information and the principle of functioning of components
Problem diagnostics of components of a combination of devices
Removal, service and installation of a combination of devices, check of a condition of components
Heating of back glass and rear-view mirrors - the general information, check of serviceability of functioning of components, recovery repair of a thermoelectric heating element
Heating of brushes of screen wipers - the general information, check of serviceability of functioning of components, recovery repair of a thermoelectric heating element
Removal, check of a state and installation of switches of management of functioning of the electric drive of regulators of window regulators
The electric drive of rear-view mirrors - check of serviceability of functioning
Removal check and installation of the switch of management of functioning of the electric drive of external rear-view mirrors
Removal, check of a state and installation of the switch of management of functioning of the electric drive of the top hatch
Removal, check of a state and installation of the combined understeering switches
Check of serviceability of functioning of electric motors of the drive of screen wipers, removal, check and installation of the operating relay of a back screen wiper on the Legacy Station wagon/Outback models
Check of the relay and switches of lighting and alarm devices
Removal and installation of illuminants, replacement of lamps
Removal, check of a state and installation of horns and switch of a horn
Check of a state and replacement of contact group of the switch of ignition
The uniform lock - the device, the principle of functioning, diagnostics of malfunctions
Removal, check of a state and installation of components of the uniform lock
System of an immobilization of the engine - the device, the principle of functioning, diagnostics of malfunctions
Removal and installation of components of system of an immobilization of the engine
Removal and installation of assembly of the radio receiver
Removal and installation of loudspeakers
Check of a state and recovery repair of the window antenna of the radio receiver
Removal, installation and check of a condition of the antenna amplifier of the radio receiver
Removal and installation of the lighter
+ Schemes of electric connections
|
The relay - the general information and check of serviceability of functioning For giving of power supply or a signal of management on many of consumers of the electric power in the car (such as components of system of injection of fuel, a horn, a starter, the cooling system fan(s), fog lights and so forth) relays are used. Can be classified by the initial condition of the relay as normally closed, normally opened and the displaced type.
Actually, the relay represents the electric key providing short circuit of VV of a contour on NV to a signal. In case of a relay exit out of operation there is a refusal of functioning of the corresponding consumer. The most part of the relay is located in a motive compartment, others "are scattered" on the car. The description of check of serviceability of functioning of the relay is given below. The failed relays are subject to replacement.
Check
Correctness of connection of the relay can always be determined by the schemes of electric connections provided in the last Section of the present Chapter.
Usually the contour of management is always connected to two of contact plugs of the relay. When giving on these NV plugs of tension current starts circulating on a winding of management of the relay therefore there is a short circuit of big contacts of a working contour of the consumer of the electric power. Other plugs are plugs of working (VV) of a contour and become isolated among themselves when giving food on a contour of management.
For the purpose of simplification of identification of plugs of the relay explanatory marking with the image of the scheme of connection of keys is usually applied on its case. If similar marking is absent, it is necessary to address to schemes of electric connections.
For check connect an ohmmeter between two VV plugs of a contour of the relay, - in the relay of normally opened type conductivity has to be absent. Now connect the wire crossing point equipped with a safety lock between one of plugs of management of the relay and the positive plug of the battery (In +). By means of other wire crossing point ground the second plug of management, - the relay has to publish click after which the ohmmeter will record conductivity existence (the relay of normally opened type). Some relays demand obligatory observance of polarity of connection.
At negative result of check replace the relay. |
|
