Subaru of Legasi, Autbek
+ Cars Subaru Legacy, Outback
+ Operation manual
+ Routine maintenance
- Engine
Specifications
Check of compression pressure in cylinders and tightness of the block
Diagnostics of a condition of the engine with use of the vacuum gage
The engine lubrication system - the general information
+ the repair Procedures which are not connected with extraction of the engine from the car - four-cylinder engines
- The repair procedures which are not connected with extraction of the engine from the car - six-cylinder engines
Reduction of the piston of the first cylinder in situation VMT
Check and adjustment of valvate gaps
Removal and installation of a pulley of a cranked shaft
Removal and installation of covers of the GRM drive
Removal and installation of gas-distributing chains
Removal and installation of asterisks of the drive of camshafts
Removal and installation of an asterisk of a cranked shaft
Automatic natyazhitel of a gas-distributing chain - the general information
Removal and installation of camshafts
Removal and installation of heads of cylinders
Removal and installation of the lower section of the pallet of a case and maslozabornik
Removal, service and installation of the oil pump
Service of the reducing valve of the oil pump
Check of pressure of motive oil
Removal and installation of the sensor switch of pressure of oil
Removal and installation of the oil cooler
Removal and installation of a driving disk
Replacement of support of a suspension bracket of the power unit
+ General and capital repairs of engines
+ Cooling systems, heating
+ Power supply system and release
+ Electric equipment of the engine
+ Manual box and differential
+ Automatic transmission
+ Coupling
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
|
Automatic natyazhitel of a gas-distributing chain - the general information
Components of an automatic natyazhitel of a gas-distributing chain
The design of an automatic natyazhitel of a gas-distributing chain is shown on an illustration.
The left and right driving chains are equipped by individual natyazhitel. Natyazhiteli of hydraulic type use pressure of motive oil and are capable to support automatically a tension of driving chains in the set range, excepting thereby need for manual adjustment.
In the case of a natyazhitel there is an oil opening which on the established natyazhitel is joined to the corresponding opening in the block of cylinders. In the case of a natyazhitel the chamber of a high pressure with a control ball is located. Pressure in a chamber is regulated by the reducing valve. Thanks to a plunger with an external carving the natyazhitel is capable to hold a tightness of a driving chain at the set level even at the killed engine. |
|
