Subaru Legacy/Outback

1999-2003 of release

Repair and operation of the car



Subaru of Legasi, Autbek
+ Cars Subaru Legacy, Outback
+ Operation manual
+ Routine maintenance
- Engine
   Specifications
   Check of compression pressure in cylinders and tightness of the block
   Diagnostics of a condition of the engine with use of the vacuum gage
   The engine lubrication system - the general information
   + the repair Procedures which are not connected with extraction of the engine from the car - four-cylinder engines
   - The repair procedures which are not connected with extraction of the engine from the car - six-cylinder engines
      Reduction of the piston of the first cylinder in situation VMT
      Check and adjustment of valvate gaps
      Removal and installation of a pulley of a cranked shaft
      Removal and installation of covers of the GRM drive
      Removal and installation of gas-distributing chains
      Removal and installation of asterisks of the drive of camshafts
      Removal and installation of an asterisk of a cranked shaft
      Automatic natyazhitel of a gas-distributing chain - the general information
      Removal and installation of camshafts
      Removal and installation of heads of cylinders
      Removal and installation of the lower section of the pallet of a case and maslozabornik
      Removal, service and installation of the oil pump
      Service of the reducing valve of the oil pump
      Check of pressure of motive oil
      Removal and installation of the sensor switch of pressure of oil
      Removal and installation of the oil cooler
      Removal and installation of a driving disk
      Replacement of support of a suspension bracket of the power unit
   + General and capital repairs of engines
+ Cooling systems, heating
+ Power supply system and release
+ Electric equipment of the engine
+ Manual box and differential
+ Automatic transmission
+ Coupling
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment




d9f1bda0

The repair procedures which are not connected with extraction of the engine from the car - six-cylinder engines

Reduction of the piston of the first cylinder in situation VMT

For reduction of the engine in position VMT of the piston of the first cylinder follows, rotating a cranked shaft clockwise, to achieve removal of an adjusting tag on a shaft asterisk in situation for 12 hours.