Subaru Legacy/Outback

1999-2003 of release

Repair and operation of the car



Subaru of Legasi, Autbek
+ Cars Subaru Legacy, Outback
+ Operation manual
+ Routine maintenance
- Engine
   Specifications
   Check of compression pressure in cylinders and tightness of the block
   Diagnostics of a condition of the engine with use of the vacuum gage
   The engine lubrication system - the general information
   + the repair Procedures which are not connected with extraction of the engine from the car - four-cylinder engines
   - The repair procedures which are not connected with extraction of the engine from the car - six-cylinder engines
      Reduction of the piston of the first cylinder in situation VMT
      Check and adjustment of valvate gaps
      Removal and installation of a pulley of a cranked shaft
      Removal and installation of covers of the GRM drive
      Removal and installation of gas-distributing chains
      Removal and installation of asterisks of the drive of camshafts
      Removal and installation of an asterisk of a cranked shaft
      Automatic natyazhitel of a gas-distributing chain - the general information
      Removal and installation of camshafts
      Removal and installation of heads of cylinders
      Removal and installation of the lower section of the pallet of a case and maslozabornik
      Removal, service and installation of the oil pump
      Service of the reducing valve of the oil pump
      Check of pressure of motive oil
      Removal and installation of the sensor switch of pressure of oil
      Removal and installation of the oil cooler
      Removal and installation of a driving disk
      Replacement of support of a suspension bracket of the power unit
   + General and capital repairs of engines
+ Cooling systems, heating
+ Power supply system and release
+ Electric equipment of the engine
+ Manual box and differential
+ Automatic transmission
+ Coupling
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment




d9f1bda0

Replacement of support of a suspension bracket of the power unit

The device of support of a suspension bracket of the power unit on models of 3.0 l

1 — the Diaphragm
2 — the Air chamber
3 — the Liquid chamber

4 — the Throttle opening
5 — the Membrane
6 — the Rubber pillow


Design and details of installation of support of a suspension bracket of the power unit

1 — Rubber pillows

Efforts of a tightening of threaded connections, Nanometer

T1: 34
T2: 74


 PERFORMANCE ORDER

1. The H6 engine is supported by specially developed elastic support filled with liquid. Each support is rigidly attached to the engine in three points. Support are capable to reduce effectively the level of vibrations and noise thanks to existence of the membrane established between two chambers filled with liquid. The similar design allows to reduce the springing support constant.
2. The design and details of installation of support of a suspension bracket of the power unit are shown on an illustration.
3. Remove the power unit (see the Section Removal of the Power Unit from the Car - methods of performance and a precautionary measure).
4. Remove support from the unit and attentively check rubber pillows for existence of signs of aging of material, deformations, cracks and other mechanical damages.
5. Installation is made upside-down.