1. Remove a pulley of a cranked shaft (see the Section Removal and installation of a pulley of a cranked shaft).
2. Remove a forward cover of the GRM drive (see the Section Removal and installation of covers of the GRM drive).
3. Remove a gas-distributing chain (see the Section Removal and installation of gas-distributing chains).
|
|
4. By means of a special head (ST 18231AA000) release fixture of an asterisk of a camshaft. |
5. Check asterisk teeths for existence of signs of excessive wear, scratches and other mechanical damages.
6. Installation is made upside-down. Check density of landing of an asterisk on a spline, track that the fixture was tightened with the demanded effort (13 Nanometers). |
