Subaru Legacy/Outback

1999-2003 of release

Repair and operation of the car



Subaru of Legasi, Autbek
+ Cars Subaru Legacy, Outback
+ Operation manual
+ Routine maintenance
- Engine
   Specifications
   Check of compression pressure in cylinders and tightness of the block
   Diagnostics of a condition of the engine with use of the vacuum gage
   The engine lubrication system - the general information
   + the repair Procedures which are not connected with extraction of the engine from the car - four-cylinder engines
   - The repair procedures which are not connected with extraction of the engine from the car - six-cylinder engines
      Reduction of the piston of the first cylinder in situation VMT
      Check and adjustment of valvate gaps
      Removal and installation of a pulley of a cranked shaft
      Removal and installation of covers of the GRM drive
      Removal and installation of gas-distributing chains
      Removal and installation of asterisks of the drive of camshafts
      Removal and installation of an asterisk of a cranked shaft
      Automatic natyazhitel of a gas-distributing chain - the general information
      Removal and installation of camshafts
      Removal and installation of heads of cylinders
      Removal and installation of the lower section of the pallet of a case and maslozabornik
      Removal, service and installation of the oil pump
      Service of the reducing valve of the oil pump
      Check of pressure of motive oil
      Removal and installation of the sensor switch of pressure of oil
      Removal and installation of the oil cooler
      Removal and installation of a driving disk
      Replacement of support of a suspension bracket of the power unit
   + General and capital repairs of engines
+ Cooling systems, heating
+ Power supply system and release
+ Electric equipment of the engine
+ Manual box and differential
+ Automatic transmission
+ Coupling
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment









d9f1bda0


Removal and installation of the oil cooler

 PERFORMANCE ORDER

1. The car also establish to Poddomkratta it on props.

2. Remove protection of a case.

3. Empty the cooling system (see the Head Routine maintenance).
4. Merge motive oil (see the Head Routine maintenance).

5. Turn out fastening bolts to the engine of a tube of a cooling path.

6. Disconnect water hoses from the oil cooler.


7. Remove an oil filter (see the Head Routine maintenance).

8. Take the nipple socket and remove the oil cooler from the top section of the pallet of a case.

And — the Nipple socket
In — the Oil cooler
With — the Sealing ring
Efforts of a tightening of threaded connections, Nanometer
Т: 54 Nanometers


9. By method of a purge make sure of passability of channels of cooling liquid.
10. Estimate a condition of the interfaced surface of the top section of the pallet of a case and an oil filter (do not forget to check a flute under installation of a sealing ring).
11. Installation is made upside-down. Track that all fixture was tightened with the demanded effort (see Specifications and accompanying illustrations to this Section).