|
1. Remove a pulley of a cranked shaft (see the Section Removal and installation of a pulley of a cranked shaft).
2. Remove a forward cover of the GRM drive (see the Section Removal and installation of covers of the GRM drive).
3. Remove a gas-distributing chain (see the Section Removal and installation of gas-distributing chains).
4. Remove asterisks of camshafts (see the Section Removal and installation of asterisks of the drive of camshafts).
5. Remove an asterisk of a cranked shaft.
6. Check asterisk teeths for existence of excessive wear, scratches and other mechanical damages. Make sure of integrity and readability of a basic tag of the CKP sensor.
7. Installation is made upside-down. Check density of landing of an asterisk on a spline. |
