Subaru Legacy/Outback

1999-2003 of release

Repair and operation of the car

Subaru of Legasi, Autbek
+ Cars Subaru Legacy, Outback
+ Operation manual
+ Routine maintenance
- Engine
   Specifications
   Check of compression pressure in cylinders and tightness of the block
   Diagnostics of a condition of the engine with use of the vacuum gage
   The engine lubrication system - the general information
   - The repair procedures which are not connected with extraction of the engine from the car - four-cylinder engines
      Reduction of the piston of the first cylinder in situation VMT
      Check and adjustment of valvate gaps
      Removal and installation of a pulley of a cranked shaft
      Removal and installation of forward covers of the GRM drive
      Removal and installation of a belt of the GRM drive, check of a condition of components
      Removal, check of a state and installation of cogwheels of camshafts
      Removal and installation of a cogwheel of a cranked shaft
      Natyazhitel of a gas-distributing belt - the general information and the principle of functioning
      Removal, check of a state and installation of elements of the drive of valves
      Removal and installation of camshafts
      Removal and installation of heads of cylinders
      Removal and installation of the pallet of a case and maslozabornik
      Removal, service and installation of the oil pump
      Check of pressure of motive oil
      Removal and installation of the sensor switch of pressure of oil
      Removal, check of a state and installation of a flywheel / driving disk
      Replacement of support of a suspension bracket of the power unit
   + the repair Procedures which are not connected with extraction of the engine from the car - six-cylinder engines
   + General and capital repairs of engines
+ Cooling systems, heating
+ Power supply system and release
+ Electric equipment of the engine
+ Manual box and differential
+ Automatic transmission
+ Coupling
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment

Removal and installation of the sensor switch of pressure of oil

REMOVAL

PERFORMANCE ORDER

1. Remove the generator from a basic arm (see the Head Elektrooborudovaniye of the engine).

2. Disconnect an electrical wiring from the sensor switch of pressure of motive oil.

3. Turn out the sensor switch from the engine block.

INSTALLATION

PERFORMANCE ORDER

1. Before installation grease carving part of the sensor switch with sealant like Three Bond 1215.

2. Screw the sensor switch on the regular place and tighten it with the demanded effort (25 Nanometers).
3. Connect the socket of the sensor switch of oil pressure.
4. Install into place the generator.
5. Start the engine and check an installation site of the sensor switch of oil pressure existence of leak of motive oil.