Subaru Legacy/Outback

1. Details of installation of a rear bumper on the Sedan models Legacy are presented on an illustration.
2. A car back also establish to Poddomkratta it on props.

3. Turn out bolts and take fikdostup to which opens from under the car.

4. Release clamps and remove a slip from bottom edge of an aperture of a luggage compartment.

5. For the purpose of a possibility of procrastination of back edges of panels of a lateral upholstery of a luggage compartment, remove the hooks established in the top corners of an aperture. And — the Hook

6. Unbend back edges of lateral panels of finishing and give four (on two from each party back panels) nuts of fastening of assembly of a rear bumper.

7. Take the top clamps and separate an overlay of a bumper from the bearing beam.

1. Details of installation of a rear bumper on the Legacy Station wagon/Outback models are presented on an illustration.
2. A car back also establish to Poddomkratta it on props.

3. Turn out bolts and take clamps of fastening of an overlay of a bumper access to which opens from under the car.

4. Remove the lateral panels of a floor of a luggage compartment equipped with boxes (see the Section Removal and installation of elements of internal finishing), unbend back edges of panels of a lateral upholstery of a luggage compartment and remove protective covers of heads of back bolts.

5. Release four (under two from each party of a luggage compartment) fixing stir remove assembly of a rear bumper from the car.

6. Take the remained top and lower clamps and separate a slip from a bumper beam.