Subaru Legacy/Outback

1999-2003 of release

Repair and operation of the car

Removal and installation of panels of an internal upholstery of doors, including a back door (the Station wagon models Legacy and Outback) and a cover of a luggage compartment (Sedan model)

Details of installation of panels of an internal upholstery of doors of the car


1 — the Triangular panel of finishing of a support of a door mirror 2 — the Arm of a support of a door mirror 3 — the Top rubber sealant 4 — the Clamp 5 — the Pillow 6 — the upholstery Panel	7 — Assemblies of switches of the electric drive of window regulators 8 — Nizhny Novgorod a rubber sealant 9 — the Top panel of an upholstery 10 — Lateral section of the top panel of an upholstery 11 — the Lower panel of an upholstery

Forward doors

PERFORMANCE ORDER

1. Remove the panel of facing of the internal handle of a door, - for an otpuskaniye of the top clamp the panel should be delayed on itself, lower - to wring out down.

2. Release two clamps and release the panel of switches of the electric drive of window regulators / external rear-view mirrors from a door armrest.

3. Disconnect an electrical wiring and remove the panel of switches.

4. Turn out three fixing screws and release a forward clamp of fastening of the panel of an internal upholstery.

5. Remove the triangular panel of internal finishing of a support of a door rear-view mirror.

6. Accurately take seven plastic clamps located on perimeter of the panel of an internal upholstery of a door.

7. Separate the panel from a door and remove it from a frame of the last.

8. Remove a door loudspeaker (see the Head Onboard electric equipment) and accurately separate an insulating slip from the door panel. Try not to damage a slip or a butyl tape of its fastening, - violation of integrity of insulating materials is fraught with hit in a moisture doorframe, - in case of need replace a slip.

9. Installation is made upside-down, - track reliability of a zashchelkivaniye of clamps. For fixing of a new insulating slip use a butyl 3M8626 tape.

Back doors

The order of performance of procedure is similar described above for forward doors adjusted for lack of need for removal of the triangular panel of finishing of a support of a mirror.

Back door (Station wagon models Legacy and Outback)

PERFORMANCE ORDER

1. Release fixing clamps and remove the lower panel of an upholstery of a door of a back.

2. Release two clamps and uncover a stoplight of the top level.

3. Release two fixing clamps and remove the top panel of an upholstery of a door of a back.

4. Installation is made upside-down.

Cover of a luggage compartment (Sedan model)

PERFORMANCE ORDER

1. Open a cover of a luggage compartment.

2. Release fixing clamps and remove the panel of an internal upholstery of a cover.

3. Installation is made upside-down.