|
1. Make sure of lack of leakages of ATF around an entrance to transmission of the driveshaft. In case of need replace an epiploon of a casing of lengthening of AT (see further).
2. Carefully clear transmission outside.
3. Turn out a drain stopper and merge ATF, then wrap a stopper on a place and tighten it with the demanded effort.
4. Remove assembly of back section of system of production of the fulfilled gases with the muffler.
5. Uncover the thermofilter.
6. Remove the driveshaft (see the Head Stsepleniye).
7. By means of a stripper of ST 398527700 take an old epiploon.
8. By means of a mandrel of ST 498057300 put a new epiploon in the transmission lengthening case.
9. Further installation is made upside-down. Track that all fixture was tightened with the demanded effort. |
