Subaru Legacy/Outback

1999-2003 of release

Repair and operation of the car



Subaru of Legasi, Autbek
+ Cars Subaru Legacy, Outback
+ Operation manual
+ Routine maintenance
+ Engine
+ Cooling systems, heating
+ Power supply system and release
+ Electric equipment of the engine
+ Manual box and differential
- Automatic transmission
   Specifications
   Electrohydraulic control system - the general information, purpose of basic elements
   System of self-diagnostics - the general information and the principles of functioning
   Diagnostics of the general condition of AT
   Problem diagnostics of AT
   Removal and installation of transmission assembly
   Replacement of elements of a suspension bracket of transmission assembly
   Replacement of an epiploon of a casing of lengthening of AT
   Check of a state, adjustment and replacement of the sensor switch of permission of start
   Removal and installation of the forward sensor of the speed (VSS)
   Removal and installation of the back sensor of the speed (VSS)
   Removal and installation of the sensor of turns of the turbine of the hydrotransformer
   Removal, service and installation of valvate assembly
   Replacement of electromagnetic valves of switching, executive electromagnetic valves and sensor of temperature of ATF
   Replacement of the ATF filter
   Removal and installation of the module of management of transmission (TCM)
   Removal, installation and check of a condition of lines of a path of cooling of ATF
   Removal, service and installation of components of the lever of the AT selector
   Removal, installation, check of a state and adjustment of a driving cable of the AT selector
+ Coupling
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment




d9f1bda0



Removal, installation and check of a condition of lines of a path of cooling of ATF

REMOVAL

 PERFORMANCE ORDER

1. Tire out the car on the elevator.
2. Remove the battery and the tank of liquid of washing of glasses (see the Head Kuzov).
3. Lift the car.
4. Remove protection of a case (see the Head Kuzov).
5. Disconnect a hose of a path of cooling of ATF from a radiator.

 Do not hook a hose the pointed subjects! In case of difficulties wind the end of a hose with rags and after scrolling by flat-nose pliers, remove it hands.

6. Disconnect hoses of a path of cooling of ATF from tubes/transmission.


L models 2.0 and 2.5

 PERFORMANCE ORDER

1. Pick up the phone of a path of cooling of ATF from a frame.

2. Remove inlet and final tubes of the oil cooler.

 e lose the balls and springs used together with screws.


A — the Inlet tube
B — the Final tube


Models of 3.0 l

 PERFORMANCE ORDER

1. Remove a loker of protection of an arch of the left forward wheel (see the Head Kuzov).
2. Disconnect hoses of a path of cooling of ATF from the ATF filter.

3. Disconnect a tube of a path of cooling of ATF from a frame.

4. Remove inlet and final tubes of the oil cooler.

INSTALLATION

 PERFORMANCE ORDER

Installation is made as it should be, the return to an order of dismantle of components. Track that all fixture was tightened with the demanded effort, and hoses were not overwound or bent.

CHECK

 PERFORMANCE ORDER

1. Check places of connection of hoses to tubes, a radiator and transmission for existence of signs of development of leakages of ATF.
2. Make sure of integrity and reliability of a tightening of collars.
3. Slightly bending hoses, check them for existence of cracks and other damages.
4. To the touch estimate elasticity of hoses, especially in fixing places their collars.
5. Replace the failed components.