Subaru of Legasi, Autbek
+ Cars Subaru Legacy, Outback
+ Operation manual
+ Routine maintenance
+ Engine
+ Cooling systems, heating
+ Power supply system and release
+ Electric equipment of the engine
+ Manual box and differential
- Automatic transmission
Specifications
Electrohydraulic control system - the general information, purpose of basic elements
System of self-diagnostics - the general information and the principles of functioning
Diagnostics of the general condition of AT
Problem diagnostics of AT
Removal and installation of transmission assembly
Replacement of elements of a suspension bracket of transmission assembly
Replacement of an epiploon of a casing of lengthening of AT
Check of a state, adjustment and replacement of the sensor switch of permission of start
Removal and installation of the forward sensor of the speed (VSS)
Removal and installation of the back sensor of the speed (VSS)
Removal and installation of the sensor of turns of the turbine of the hydrotransformer
Removal, service and installation of valvate assembly
Replacement of electromagnetic valves of switching, executive electromagnetic valves and sensor of temperature of ATF
Replacement of the ATF filter
Removal and installation of the module of management of transmission (TCM)
Removal, installation and check of a condition of lines of a path of cooling of ATF
Removal, service and installation of components of the lever of the AT selector
Removal, installation, check of a state and adjustment of a driving cable of the AT selector
+ Coupling
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
|
Replacement of elements of a suspension bracket of transmission assembly
Limiter of rocking of the power unit
|
|
|
1. Disconnect a negative wire from the battery.
2. Remove an air cleaner/airreception a chamber (see the Section Service of Components of an inlet air path of the Head of the Power supply system and release).
3. Remove the rocking limiter (see the Head Dvigatel).
4. Make sure that the bar of the limiter is not bent and it is not damaged. Estimate a condition of rubber-metal plugs. In case of need make the corresponding recovery repair, or replace the limiter.
5. Installation is made upside-down, - track that all fixture was tightened with the demanded effort. |
|
Cross beam and rubber pillow of a support
|
|
|
1. Disconnect a negative wire from the battery.
2. The car also establish to Poddomkratta it on props.
3. Remove reception, central and back sections of system of production of the fulfilled gases together with the muffler (see the Head of the Power supply system and release).
4. Uncover the thermofilter.
5. Prop up AT a special transmission jack, - track that persistent plates of transmission did not rest against the pallet.
6. Remove a back cross beam of transmission.
7. Remove a rubber pillow of a back support of a suspension bracket of the power unit.
8. Make sure that the cross beam is not bent and it is not damaged, and also that the rubber pillow did not lose elasticity, did not crack or by a different way it is not damaged. Make necessary recovery repair, or replace the failed components.
9. Installation is made upside-down, - track that all fixture was tightened with the demanded effort. |
|
|
|
