|
|
Detachment/connection of hoses should be made, without using to them the twisting efforts! Watch that the connected hoses were not overwound. The open ends of refrigerator lines should be corked with suitable caps at once! |
1. Make central air discharge in the conditions of a specialized workshop.
2. Disconnect a negative wire from the battery.
3. Remove an air inlet (see the Section Service of Components of an Inlet Air Path).
4. Turn out fixing bolts (C), disconnect a low pressure hose from the evaporator and the compressor and remove it from the car.
5. Turn out bolts (D), disconnect a high-pressure hose from the compressor and the condenser and remove it from the car.
6. Attentively study a condition of the removed hoses. In case of identification of cracks, cuts and other damages replace defective components.
7. Installation is made upside-down, - add 1 ml of refrigerator oil in the compressor.
|
|
The recharge of central air has to be made in the conditions of a workshop of car service. |
|
