Subaru of Legasi, Autbek
+ Cars Subaru Legacy, Outback
+ Operation manual
+ Routine maintenance
+ Engine
- Cooling systems, heating
Specifications
+ engine Cooling system
- Systems of heating/ventilation/air conditioning
Removal and installation of deflectors and air ducts
Removal and installation of resistive assembly of a driving electric motor of the fan of a heater
Removal, check and installation of a driving electric motor of the fan of a heater
Removal and installation of the control panel functioning of systems of heating/ventilation/air conditioning
Removal and installation of assembly of a heater
Removal and installation of the heat exchanger of a heater
Check of serviceability of functioning and service of systems of heating and air conditioning
The K/V compressor - a design and the principle of functioning
The K/V condenser - a design and the principle of functioning
Receiver dehumidifier To/in - a design and the principle of functioning
Pressure sensor switch To/in - a design and the principle of functioning
The K/V evaporator - a design and the principle of functioning
The K/V broad valve - a design and the principle of functioning
Check of a state, removal and installation of the compressor of system To/in
Removal and installation of the condenser of system To/in
Removal and installation of a receiver dehumidifier of system To/in
Removal and installation of the inlet block of system To/in, replacement of the evaporator
Replacement of connecting hoses of a refrigerator path
Check of serviceability of functioning of the sensor switch of pressure
Removal and installation of information sensors of system of automatic central air (climate control)
+ Power supply system and release
+ Electric equipment of the engine
+ Manual box and differential
+ Automatic transmission
+ Coupling
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
|
Removal, check and installation of a driving electric motor of the fan of a heater
REMOVAL
|
|
1. Disconnect a negative wire from the battery.
2. Remove a ware box (see the Head Kuzov).
|
|
3. Turn out bolts of fastening of a basic arm of a plait of an electrical wiring. |
|
|
4. Give nuts of racks of the block of remote control of the uniform lock and the CRU block. |
5. Disunite the contact socket of the electric drive of the top hatch.
|
|
6. Disunite the contact socket of an electrical wiring of the servo-driver. |
|
|
7. Disconnect an electrical wiring from a fan drive electric motor. |
|
|
8. Turn out three fixing screws, disconnect an aspiratorny tube (And) and remove an electric motor.
And — Aspiratornaya a tube |
|
|
CHECK
|
|
|
|
Connect the plug No. 1 of the contact socket of an electric motor to a positive pole of the battery, ground the plug No. 2. Make sure of smoothness of rotation of the motor. |
|
|
INSTALLATION
|
|
|
Installation is made as it should be, the return to an order of dismantle of components. |
|
|
|
