Subaru Legacy/Outback

1999-2003 of release

Repair and operation of the car



Subaru of Legasi, Autbek
+ Cars Subaru Legacy, Outback
+ Operation manual
+ Routine maintenance
+ Engine
- Cooling systems, heating
   Specifications
   + engine Cooling system
   - Systems of heating/ventilation/air conditioning
      Removal and installation of deflectors and air ducts
      Removal and installation of resistive assembly of a driving electric motor of the fan of a heater
      Removal, check and installation of a driving electric motor of the fan of a heater
      Removal and installation of the control panel functioning of systems of heating/ventilation/air conditioning
      Removal and installation of assembly of a heater
      Removal and installation of the heat exchanger of a heater
      Check of serviceability of functioning and service of systems of heating and air conditioning
      The K/V compressor - a design and the principle of functioning
      The K/V condenser - a design and the principle of functioning
      Receiver dehumidifier To/in - a design and the principle of functioning
      Pressure sensor switch To/in - a design and the principle of functioning
      The K/V evaporator - a design and the principle of functioning
      The K/V broad valve - a design and the principle of functioning
      Check of a state, removal and installation of the compressor of system To/in
      Removal and installation of the condenser of system To/in
      Removal and installation of a receiver dehumidifier of system To/in
      Removal and installation of the inlet block of system To/in, replacement of the evaporator
      Replacement of connecting hoses of a refrigerator path
      Check of serviceability of functioning of the sensor switch of pressure
      Removal and installation of information sensors of system of automatic central air (climate control)
+ Power supply system and release
+ Electric equipment of the engine
+ Manual box and differential
+ Automatic transmission
+ Coupling
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment




d9f1bda0

Removal and installation of a receiver dehumidifier of system To/in

 PERFORMANCE ORDER

1. Make central air discharge in the conditions of a specialized workshop.
2. Disconnect a negative wire from the battery.

3. Disconnect from assembly of a receiver dehumidifier an electrical wiring of the sensor switch of pressure (And) and a tube (In), then turn out fixing bolts (C) and remove a receiver.

The receiver dehumidifier is filled sikkativy, in order to avoid hit in a moisture filler at once to a zakuporta open unions of assembly.

If the receiver dehumidifier is subject to replacement, add the corresponding amount of refrigerator oil (5 ml) in the compressor.


And — the Contact socket of an electrical wiring of the sensor switch of pressure
In — the Tube
With — Fixing bolts

4. Installation is made upside-down. Do not forget to replace sealing rings.

 The recharge of central air has to be made in the conditions of a workshop of car service.