Subaru Legacy/Outback

1999-2003 of release

Repair and operation of the car



Subaru of Legasi, Autbek
+ Cars Subaru Legacy, Outback
+ Operation manual
+ Routine maintenance
+ Engine
- Cooling systems, heating
   Specifications
   + engine Cooling system
   - Systems of heating/ventilation/air conditioning
      Removal and installation of deflectors and air ducts
      Removal and installation of resistive assembly of a driving electric motor of the fan of a heater
      Removal, check and installation of a driving electric motor of the fan of a heater
      Removal and installation of the control panel functioning of systems of heating/ventilation/air conditioning
      Removal and installation of assembly of a heater
      Removal and installation of the heat exchanger of a heater
      Check of serviceability of functioning and service of systems of heating and air conditioning
      The K/V compressor - a design and the principle of functioning
      The K/V condenser - a design and the principle of functioning
      Receiver dehumidifier To/in - a design and the principle of functioning
      Pressure sensor switch To/in - a design and the principle of functioning
      The K/V evaporator - a design and the principle of functioning
      The K/V broad valve - a design and the principle of functioning
      Check of a state, removal and installation of the compressor of system To/in
      Removal and installation of the condenser of system To/in
      Removal and installation of a receiver dehumidifier of system To/in
      Removal and installation of the inlet block of system To/in, replacement of the evaporator
      Replacement of connecting hoses of a refrigerator path
      Check of serviceability of functioning of the sensor switch of pressure
      Removal and installation of information sensors of system of automatic central air (climate control)
+ Power supply system and release
+ Electric equipment of the engine
+ Manual box and differential
+ Automatic transmission
+ Coupling
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment




d9f1bda0

Pressure sensor switch To/in - a design and the principle of functioning

The principle of functioning of the sensor switch of pressure To/in

1 — Shtyrevaya the plug
2 — Contact points
3 — the Directing pin

4 — the Pusher
5 — the Disk spring of a high pressure
6 — the Disk spring of low pressure


The sensor switch of pressure is switched on in the line of a high pressure of a receiver dehumidifier and serves for shutdown of the K/V compressor at excessive increase or pressure drop in the line.

So lowering of pressure in the high-pressure line is lower than 177 kPas the sensor switch perceives as a signal of development of leak of coolant and stops the compressor in order to avoid irreversible losses of a working body, excessively high pressure in the line (over 2940 kPas) can lead to destruction of components of a refrigerator path and also demands shutdown of the compressor.