|
1. Disconnect a negative wire from the battery.
2. Having pulled outside, release LLC.
3. Remove the air cleaner (see the Head of the Power supply system and release).
|
|
4. Release collars and disconnect heating hoses from heat exchanger branch pipes on a back partition of a motive compartment. |
5. Remove the inlet block of system To/in (see the Section Removal and installation of the inlet block of system To/in, replacement of the evaporator).
|
|
6. By means of a key like TORX turn out screws of fastening of the SRS control unit. |
|
|
7. Disunite the contact socket of the main plait of an electrical wiring of SRS near a basic beam of a steering column. |
8. Release fixing bolts and nuts of fastening of a basic beam.
9. Disunite the servo-driver socket.
|
|
10. Release fixing bolts and nuts and remove assembly of a heater. |
11. Installation is made upside-down. |
