Subaru Legacy/Outback

1999-2003 of release

Repair and operation of the car



Subaru of Legasi, Autbek
+ Cars Subaru Legacy, Outback
+ Operation manual
+ Routine maintenance
+ Engine
- Cooling systems, heating
   Specifications
   + engine Cooling system
   - Systems of heating/ventilation/air conditioning
      Removal and installation of deflectors and air ducts
      Removal and installation of resistive assembly of a driving electric motor of the fan of a heater
      Removal, check and installation of a driving electric motor of the fan of a heater
      Removal and installation of the control panel functioning of systems of heating/ventilation/air conditioning
      Removal and installation of assembly of a heater
      Removal and installation of the heat exchanger of a heater
      Check of serviceability of functioning and service of systems of heating and air conditioning
      The K/V compressor - a design and the principle of functioning
      The K/V condenser - a design and the principle of functioning
      Receiver dehumidifier To/in - a design and the principle of functioning
      Pressure sensor switch To/in - a design and the principle of functioning
      The K/V evaporator - a design and the principle of functioning
      The K/V broad valve - a design and the principle of functioning
      Check of a state, removal and installation of the compressor of system To/in
      Removal and installation of the condenser of system To/in
      Removal and installation of a receiver dehumidifier of system To/in
      Removal and installation of the inlet block of system To/in, replacement of the evaporator
      Replacement of connecting hoses of a refrigerator path
      Check of serviceability of functioning of the sensor switch of pressure
      Removal and installation of information sensors of system of automatic central air (climate control)
+ Power supply system and release
+ Electric equipment of the engine
+ Manual box and differential
+ Automatic transmission
+ Coupling
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment




d9f1bda0

Removal and installation of the heat exchanger of a heater

Details of installation of the heat exchanger of a heater

1 — the Drive of the ventilating gate
2 — Lateral draft
3 — the Executive lever
4 — casing Section A
5 — the air supply Gate on having blown in glasses
6 — the Ventilating gate
7 — casing Section B
8 — an air supply Air duct in foot wells
9 — the Drive of the mixing gate (model with automatic To/in)
10 — the Executive lever
11 — casing Section D
12 — the Mixing gate

13 — Section From a casing
14 — the heater Heat exchanger
15 — the Executive lever
16 — an aspirator Entrance (models with automatic To/in)
17 — the air supply Gate in foot wells

Efforts of a tightening of threaded connections, Nanometer

Т: 7.35


 PERFORMANCE ORDER

1. Details of installation of the heat exchanger of a heater are shown on an illustration.
2. Remove assembly of a heater (see the Section Removal and installation of assembly of a heater).
3. Turn out fixing screws and divide heater casing sections.

4. Take the heat exchanger.

5. Installation is made upside-down.