Subaru Legacy/Outback

1999-2003 of release

Repair and operation of the car


Subaru of Legasi, Autbek
+ Cars Subaru Legacy, Outback
+ Operation manual
+ Routine maintenance
+ Engine
+ Cooling systems, heating
+ Power supply system and release
- Electric equipment of the engine
   Specifications
   Start of the engine from the auxiliary power supply
   Removal/installation, check and service of the battery
   Check of a state and replacement of wires of the battery
   System of ignition - the general information and precautionary measures
   Check of serviceability of functioning of system of ignition
   Removal, installation and check of a condition of the module(s) of ignition
   Check and adjustment of installation of a corner of an advancing of ignition
   Replacement of CKP, CMP and KS sensors
   Service and replacement of spark plugs
   Check of a condition of high-voltage wires (4-cylinder engines)
   System of a charge - the general information and precautionary measures
   Check of a condition of system of a charge
   The generator - the general information, check and service
   Removal, dismantling, assembly and installation of the generator
   System of start - the general information and precautionary measures
   Check of serviceability of functioning of a starter and chain of start
   Nippondenso starter - check and service
   Mitsubishi starters - check and service
+ Manual box and differential
+ Automatic transmission
+ Coupling
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment



d9f1bda0

Removal, installation and check of a condition of the module(s) of ignition

4-cylinder models

Removal and installation

 PERFORMANCE ORDER

1. Disconnect a negative wire from the battery.
2. Previously having marked, disconnect an electrical wiring from bobbin assembly.

3. Turn out fixing bolts and remove the ignition module.

4. Installation is made upside-down, - tighten fixing bolts with the demanded effort (6.4 Nanometers). Track correctness of connection of an electrical wiring, - the mistake at connection can lead to an ignition module exit out of operation!

CHECK

 PERFORMANCE ORDER

1. At the switched-off ignition disconnect an electrical wiring from bobbin assembly and measure resistance between plugs No. No. 1 and 2 and No. No. 3 and 4 of the contact socket. Compare results of measurements to requirements of Specifications. Much the underestimated indications testify to existence of short circuit.

2. For check of a secondary contour measure resistance between output plugs of the module of ignition (A-B and C-D).


3. Having measured resistance between primary plug and the case of assembly (the demanded value makes not less than 10 megohms), estimate also an isolation condition
4. The faulty coil is subject to replacement.

6-cylinder models

 PERFORMANCE ORDER

1. As in system of direct ignition (DIS) of 6-cylinder engines individual bobbin modules, the description of procedures of their removal and installation see in the Section Service and replacement of spark plugs are used. A tightening of fixing bolts it is necessary to make 16 Nanometers with effort.
2. The procedure for test of bobbin assemblies is stated in the Section Check of Serviceability of Functioning of System of Ignition.