Subaru Legacy/Outback

1. Tire out the car on the elevator.
2. Disconnect a negative wire from the battery.
3. Lift the car.

4. Remove the right panel of protection of a fuel tank.

5. Get the drain capacity suitable on volume under the car, turn out a drain stopper of the main chamber and wait for the termination of an effluence of fuel.

6. Screw a stopper on a place and tighten it with the demanded effort (26 Nanometers).
7. Install into place the protective panel and tighten bolts of its fastening with effort of 18 Nanometers.

8. Lower the car on the earth, lift a pillow of a back seat and unbend a carpet. Uncover a service opening of access to an additional chamber of a fuel tank.

9. Disconnect an electrical wiring from the fuel level sensor in an additional chamber.

10. Disconnect a hose from the pumping pump.

11. Give fixing nuts and take assembly of the fuel level sensor.

12. Pump out fuel from an additional chamber of a tank by means of the suitable MANUAL pump.

Do not use for pumping out from a fuel tank power or petrol pump plants!

13. Install into place the sensor of level and tighten nuts of its fastening with the demanded effort (4.4 Nanometers).
14. Restore initial connection of electric and fuel lines.
15. Establish into place a cover of a service opening.
16. Lay the unbent site of a carpet on a place and lower a back seat.