Subaru Legacy/Outback

1999-2003 of release

Repair and operation of the car



Subaru of Legasi, Autbek
+ Cars Subaru Legacy, Outback
+ Operation manual
+ Routine maintenance
+ Engine
+ Cooling systems, heating
- Power supply system and release
   Specifications
   - System of injection of fuel
      Dropping pressure in a power supply system
      Depletion of a fuel tank
      Check of a state and replacement of fuel lines and their nipple connections
      Service of components of an inlet air path
      Removal and installation of the case of a throttle
      Service of components of the drive of a butterfly valve
      Removal, service and installation of the inlet pipeline
      Service of the fuel pump
      Removal and installation of the main MFI relay
      Removal and installation of the relay of the fuel pump
      Removal and installation of the sensor of a reserve of fuel
      Removal and installation of the fuel level sensor in an additional chamber of a fuel tank
      Removal, check and installation of the fuel filter
      Removal and installation of the locking valve of a cut-off of fuel
      Removal and installation of the damping fuel valves
      Removal and installation of a fuel tank
      Removal and installation of a jellied mouth of a fuel tank
      Removal and installation of components of system of injection of fuel
   + Control systems of the engine and decrease in toxicity of the fulfilled gases
   + System of production of the fulfilled gases
+ Electric equipment of the engine
+ Manual box and differential
+ Automatic transmission
+ Coupling
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment




d9f1bda0



Removal and installation of the sensor of a reserve of fuel

 PERFORMANCE ORDER

 The sensor of a reserve of fuel is a part of assembly of the fuel pump.

1. Take from a fuel tank assembly of the fuel pump / sensor of a reserve of fuel (see the Section Service of the Fuel Pump).
2. Remove from assembly the fuel pump (see the Section Service of the Fuel Pump).

3. Disunite contact sockets of an electrical wiring on an assembly bracket of pump assembly.

4. Having wrung out a suitable screw-driver lock uvulas, pull down and remove the fuel reserve sensor block.

5. Installation is made upside-down.

 In order to avoid fire-dangerous sparking track reliability of fixing of a wire of grounding!