Subaru Legacy/Outback

1999-2003 of release

Repair and operation of the car


Subaru of Legasi, Autbek
+ Cars Subaru Legacy, Outback
+ Operation manual
+ Routine maintenance
+ Engine
+ Cooling systems, heating
- Power supply system and release
   Specifications
   - System of injection of fuel
      Dropping pressure in a power supply system
      Depletion of a fuel tank
      Check of a state and replacement of fuel lines and their nipple connections
      Service of components of an inlet air path
      Removal and installation of the case of a throttle
      Service of components of the drive of a butterfly valve
      Removal, service and installation of the inlet pipeline
      Service of the fuel pump
      Removal and installation of the main MFI relay
      Removal and installation of the relay of the fuel pump
      Removal and installation of the sensor of a reserve of fuel
      Removal and installation of the fuel level sensor in an additional chamber of a fuel tank
      Removal, check and installation of the fuel filter
      Removal and installation of the locking valve of a cut-off of fuel
      Removal and installation of the damping fuel valves
      Removal and installation of a fuel tank
      Removal and installation of a jellied mouth of a fuel tank
      Removal and installation of components of system of injection of fuel
   + Control systems of the engine and decrease in toxicity of the fulfilled gases
   + System of production of the fulfilled gases
+ Electric equipment of the engine
+ Manual box and differential
+ Automatic transmission
+ Coupling
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment



d9f1bda0

Removal and installation of the locking valve of a cut-off of fuel

 PERFORMANCE ORDER

 See the prevention at the beginning of the Section Dropping Pressure in a power supply system!

1. Remove a fuel tank (see the Section Removal and installation of a fuel tank).
2. Release a collar and disconnect a hose of the vaporizing line from the fuel cut-off valve.

3. Give fixing nuts and remove the fuel cut-off valve.
4. Installation is made upside-down. Track that nuts of fastening of the valve were tightened with the demanded effort (4.4 Nanometers).









QX4.ONLINE
S40.ONLINE
A-8.ONLINE
W124.ONLINE
RX300.ONLINE
W140.ONLINE
B3-B4.SPACE
B3B4.SPACE
A-8.SPACE