Subaru Legacy/Outback

1999-2003 of release

Repair and operation of the car



Subaru of Legasi, Autbek
+ Cars Subaru Legacy, Outback
+ Operation manual
+ Routine maintenance
+ Engine
+ Cooling systems, heating
+ Power supply system and release
+ Electric equipment of the engine
+ Manual box and differential
+ Automatic transmission
- Coupling
   Specifications
   + Flywheel and coupling
   - Driving and cardan shaft, back differential
      The drive of forward wheels - the general information
      Removal and installation of rotary fists, service of stupichny assemblies of forward wheels
      Removal, service and installation of a forward power shaft
      The drive of back wheels - the general information
      Removal and installation of stupichny assemblies of back wheels, replacement of the back stupichny bearing
      Removal, check of a state and installation of components of the driveshaft
      Check of a state and replacement of a forward epiploon of back differential
      Removal, service, installation and adjustment of back differential of T-type
      Removal, service, installation and adjustment of back differential of VA type
      Removal, installation and check of a condition of a forward beam of fastening of back differential
      Removal, service and installation of a back power shaft
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment




d9f1bda0

Removal, installation and check of a condition of a forward beam of fastening of back differential

 PERFORMANCE ORDER

1. Disconnect a negative wire from the battery.
2. Poddomkratte car.

3. A special transmission jack prop up back differential and remove a forward beam of its fastening.

Efforts of a tightening of threaded connections, Nanometer

T1: 65
T2: 110

4. Check a forward beam of fastening of back differential for existence of damages, deformations or corrosion and if necessary replace it.
5. Check plugs of a forward beam of fastening of back differential for existence of damages, cracks or hardenings and if necessary replace them.
6. Installation is made as it should be, the return to an order of dismantle of components. Track that all fixture was tightened with the demanded effort.