Subaru Legacy/Outback

1999-2003 of release

Repair and operation of the car



Subaru of Legasi, Autbek
+ Cars Subaru Legacy, Outback
+ Operation manual
+ Routine maintenance
+ Engine
+ Cooling systems, heating
+ Power supply system and release
+ Electric equipment of the engine
+ Manual box and differential
+ Automatic transmission
- Coupling
   Specifications
   - Flywheel and coupling
      Flywheel and coupling - the general information and check of a condition of components
      Removal, check of a state and installation of components of assembly of coupling
      Removal, check of a state and installation of the vyzhimny bearing and lever of switching off of coupling
      Removal, check of a state and installation of the executive cylinder of coupling
      Removal, service and installation of components of the main cylinder of coupling
      Check of a state and replacement of connecting lines of a hydraulic path of the drive of coupling
      Check of level and replacement of hydraulic liquid of the drive of switching off of coupling
      Removal of air from a hydraulic path of the drive of switching off of coupling
      Removal, service, installation and adjustment of a pedal of coupling
      Removal, installation and check of serviceability of a condition of the sensor switch of disconnection of a chain of a starter
   + Driving and cardan shaft, back differential
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment




d9f1bda0

Removal, check of a state and installation of the executive cylinder of coupling

 PERFORMANCE ORDER

1. Remove the air cleaner case (see the Head of the Power supply system and release).
2. Disconnect from the executive cylinder a hydraulic hose, - at once to a zakuporta the open ends of a hose and the reception union in order to avoid hit of dirt in a hydraulic path.

3. Turn out fixing screws and remove the executive cylinder from RKPP case.

Efforts of a tightening of threaded connections, Nanometer

T1: 18
T2: 37

4. Attentively study a condition of the cylinder, - in case of detection of mechanical damages or signs of development of leaks, assembly of the cylinder is subject to replacement.
5. Installation is made as it should be, the return to an order of dismantle of components. Track that all fixture was tightened with the demanded effort.

 Before installation the surface of a rod of the cylinder contacting to the coupling switching off lever should be greased with greasing like Sunlight 2: P/N 003602010.

6. Remove from the cylinder air (see the Section Removal of Air from a hydraulic path of the drive of switching off of coupling) and check serviceability of functioning of coupling.