|
|
Subaru Legacy/Outback1999-2003 of releaseRepair and operation of the car |
|
|
Subaru of Legasi, Autbek + Cars Subaru Legacy, Outback - Operation manual + Access, protection + Elements of security systems + Equipment of the car, arrangement of devices and governing bodies + Comfort - Methods of operation Main cautions Running in of the new car Gas station of the car Control of level of engine oil Control of level of cooling liquid of the engine Transportation of goods in the car Start of the engine Engine stop Features of driving with a manual box of gear shifting Features of driving with automatic transmission Features of control of the all-wheel drive car Features of operation of the car equipped with system of hydrostrengthening of a wheel (GUR) Features of driving, the equipped antiretractable device, - models with RKPP (at the corresponding complete set) Braking Features of driving, VDC equipped with system of dynamic stabilization (at the corresponding complete set) Control system of speed (tempostat) Electric air suspension bracket (at the corresponding complete set) Automatic adjustment of height of provision of a back suspension bracket (Outback model) Recommendations about economy of fuel consumption Features of operation of the car equipped with the catalytic converter Parking of the car Recommendations about driving of the car in adverse weather conditions Operation of the car in the conditions of winter Towage of the trailer + Routine maintenance + Engine + Cooling systems, heating + Power supply system and release + Electric equipment of the engine + Manual box and differential + Automatic transmission + Coupling + Brake system + Suspension bracket and steering + Body + Onboard electric equipment 
|
Start of the engine Cock the parking brake.At a low temperature of air switch off everything auxiliary consumers of electric energy to reduce load of the battery. On the models equipped with RKPP squeeze out a coupling pedal against the stop and include neutral transfer. On models with AT make sure that the lever of the selector is installed in situation "P" or "N" and squeeze out a pedal of a foot brake. Without squeezing out a gas pedal, turn a key in the ignition lock in the situation "START" and include a starter. If the engine was not started at once, continue to scroll a cranked shaft a starter, remembering that duration of continuous functioning of a starter should not exceed 10 seconds. Repeated attempt of start should be made, having waited for not less than 15 seconds, - the pause is necessary for cooling of an electric motor of a starter. If the engine does not manage to be started during the continuous work of a starter within 10 seconds, or the started engine at once becomes deaf, try to execute start at the gas pedal which is squeezed out to a half. After successful start of the engine release a gas pedal to avoid sharp increase of turns. If it is not possible to start the engine still, completely squeeze out a pedal of gas and hold it in the pressed situation during the whole time of functioning of a starter, is will help to remove the excess fuel which got to the inlet pipeline and cylinders of the engine. Duration of continuous work of a starter, as well as in the previous cases, should not exceed 10 seconds. If the engine is not started after a purge of cylinders, once again try to start it at partially squeezed out gas pedal. Right after implementation of start release a pedal. Features of start of the engine in cold weather in the conditions of highlands (height more than 2400 m above sea level) At a low temperature of air start of the engine is at a loss. In the conditions of highlands where air is strongly discharged, start of the engine becomes complicated in addition. Instructions which need to be followed at start of the engine in the considered conditions are given below. Switch off everything auxiliary consumers of electric energy to reduce load of the battery. Squeeze out a pedal of gas to a half and hold it in this situation during the whole time of scrolling of a cranked shaft of the engine a starter. Duration of continuous inclusion of a starter should not exceed 15 seconds. After implementation of successful start of the engine gradually release a gas pedal, without allowing substantial increase of turns. If the engine is not started, squeeze out a gas pedal against the stop and hold it in the pressed situation during the whole time of functioning of a starter. Duration of continuous work of a starter, as well as in the previous case, should not exceed 10 seconds. If the engine is still not started, repeat attempt. At a negative temperature of air or if the car was not used within several days, let's the engine get warm within 3 ÷ 4 minutes, only after it begin the movement. |
|