Subaru Legacy/Outback

1. The car also establish to Poddomkratta it on props and remove back wheels.

2. On the Station wagon models Outback/Legacy release clamps and remove a carpet of a floor of a luggage compartment.

3. On the Sedan models remove a carpet of a floor of a luggage compartment and unbend the panel of lateral finishing from the relevant party of the car.

4. Release a fixing nut and remove a bolt of fastening of the lower support of the telescopic shock-absorber to the longitudinal lever of a back suspension bracket.

5. In a luggage compartment release nuts of fastening of the top support of the shock-absorber to the body panel.

6. Remove the shock-absorber.

1. The description of procedures of service of the shock-absorber see in the corresponding subsections of the Section Removal, service and installation of forward racks.

2. Before utilization of the failed shock-absorber it is necessary to extend against the stop outside of its piston rod and to drill an opening with a diameter of 2-3 mm in the corresponding place of the case.

1. Prop up the shock-absorber a jack and tighten with the demanded effort (30 Nanometers) NEW samokontryashchiyesya nuts of fastening of its top support to a body element.
2. Having turned, get a regular automobile jack between the cross lever of a suspension bracket and a stretcher and adjust it so that openings in the lower support of the back shock-absorber were combined with reciprocal openings in the cross lever.

In order to avoid damage of a stretcher enclose rags under a jack head.

3. A transmission jack level the longitudinal lever horizontally and tighten with the demanded effort (160 Nanometers) NEW samokontryashchuyusya a nut of a bolt of fastening of the lower support of the shock-absorber.
4. Further installation is made as it should be, the return to an order of dismantle of components.
5. In summary drive away the car on car repair shop for check and adjustment of corners of installation of back wheels.