Subaru Legacy/Outback

1. Release wheel nuts, a back of the car and establish to a poddomkratta it on props, remove back wheels.
2. Turn out bolts of collars of fastening of a bar of the stabilizer of cross resistance to a stretcher.

3. At removal right remove the right extension of a stretcher.

4. Remove the corresponding rack of the stabilizer of cross stability (see the Section Removal, check of a condition of components and installation of the back stabilizer of cross stability).
5. Level horizontally and prop up a transmission jack the longitudinal lever of a back suspension bracket.

6. Release a nut of an axial bolt of fastening of the back cross lever to the longitudinal lever of a suspension bracket.

7. Mark the adjusting provision of an adjusting/axial bolt of fastening of the internal end of the back cross lever concerning a stretcher. Holding a bolt from a provorachivaniye the second key, release a fixing nut, take an adjusting/axial bolt and remove the back cross lever.

8. Visually estimate a condition of the lever and its rubber-metal axial plugs, replace the failed components.

1. Installation is made as it should be, the return to an order of dismantle of components. Track horizontal position of an arrangement of the longitudinal lever of a suspension bracket on a jack. At installation of an internal adjusting/axial bolt see to correctness of combination of the landing tags put in the course of dismantle.
2. In summary drive away the car on car repair shop for check and adjustment of corners of installation of back wheels.