Subaru Legacy/Outback

1. Tire out the car on the elevator.
2. Disconnect a negative wire from the battery.
3. Lift the car and remove forward wheels.
4. Turn out fixing bolts and disconnect a bar of the stabilizer of cross stability and a domkratny plate from a beam.
5. Disconnect tips of steering drafts from rotary fists.
6. Remove forward section of system of production of the fulfilled gases (see the Head of the Power supply system and release).
7. Give nuts of axial bolts of fastening to a beam of cross levers of a suspension bracket.
8. Separate cross levers from a beam of a suspension bracket and the bottom of the car (see the Section Removal, service and installation of cross levers of a forward suspension bracket).
9. Give fastening nuts to the cross lever of support of a suspension bracket of the power unit.
10. Hang out the power unit from above on the winch, having raised it approximately on 10 mm.
11. Prop up a cross beam of a suspension bracket a jack, release fixing nuts, then slowly lower a beam assembled with the steering mechanism, - track that steering drafts were not hooked for covers of the hinges of equal angular speeds (HEAS).
12. Attentively examine a beam on existence of signs of excessive wear, cracks, deformations and other mechanical damages, in case of need make its replacement.
13. Installation is made upside-down. Track that all fixture was tightened with the demanded effort.
14. In summary do not forget to remove air traffic jams from a path of system of hydrostrengthening of a wheel.
15. Drive away the car on car repair shop for check and adjustment of corners of installation of forward wheels.